Rectangle mounting plate (aka. anchor plate) for key switch lock and cam lock with cutout .75" x .64" (flat)

Perfect fit for the lock. No slack, play, or gap between the lock and this plate. Fit was flawless. Strength is very good. When I hold the plate with vice grips and use a wrench to try to spin the lock in the plate, it does not budge. I used this with a replacement cylinder using a round key. Noticed the lock barrel rotating when the key was turned hard. This stopped the problem.

I was looking for something to work and came across your site, i am glad i did. i was looking for a plate to cover a larger hole but i still needed it to hold the key switch in place, the double d cutout was perfect. i usually solder the leads to the terminals on the switch , but i remember there are pins that fit. i ordered the pins with the leads cut the leads down to a point where i could solder a little heavier wire on it and then heat shrink the ends. i was thumbing through some of the items you have and i know i run across time to time needing things . so i will keep your site up on the page and refer to it often . thank you again for coming through when several of my own lock suppliers didn't have what i needed.